Arduino Micro Pro ATMEGA32U4 5V/16MHZ

4.9 (222) · € 32.50 · En Stock

, Description:, Pro Micro ATmega32U4 5V/16MHz Module Board with 2 row pin header for arduino Leonardo Replace, 1. The Pro Micro is similar to

ATmega32U4 running at 5V/16MHz Supported by IDE v1.0.1 Rx and Tx Hardware Serial Connection 4 x 10-bit ADC pins, 12 x Digital I/Os On-Board Type-C

AITRIP 2PCS Pro Micro ATmega32U4 5V 16MHz Type-C Development Module Board with 2 Row pin Header Compatible arduino Leonardo Replace ATmega328 Pro Mini

Pro Micro 5V / 16MHz - ProtoSupplies

Type-C MINI USB Pro Micro For Arduino ATmega32U4 5V/16MHz 3.3V/8Mhz Module With 2 Row Pin Header Leonardo Usb Interface Board - AliExpress

Pro Micro ATmega32U4 Board 5V 16MHz Compatible with Arduino Pro Micro ATmega32U4

ATmega32U4 Pro Micro Controller Board for Arduino Pro Micro Type-C USB 5V 16MHz

The Pro Micro is similar to the Pro Mini except it uses an ATmega32U4 rather than an ATmega328 microcontroller on board. The USB transceiver inside the 32U4 incorporates USB connectivity on-board and does away with a bulky external USB interface. This tiny micro-controller board does all of the Arduino tricks that you're familiar with: 4 channels of 10-bit ADC, 5 PWM pins, 12 DIOs as well as hardware serial connections for Rx and Tx.

Pro Micro ATmega32U4 5V 16MHz Leonardo replaces ATmega328 Pro Mini Arduino

TZT Pro Micro ATmega32U4 5V 16MHz Original Chip Replace ATmega328 For Arduino Pro Mini With 2 Row Pin Header For Leonardo UNO R3 - AliExpress

New Pro Micro ATmega32U4 5V 16MHz Replace ATmega328 Arduino Pro Mini

Pro Micro Compatible Board - 5V/16MHz

Pro Micro ATmega32U4 5V 16MHz Replace ATmega328 Arduino Pro Mini – diymore

Pro Micro Module with ATmega32U4, 5V, 16MHz, Arduino compatible

running at 5V/16MHz Supported under IDE v1.0.1 On-Board micro-USB connector for programming 4 x 10-bit ADC pins 12 x Digital I/Os

OSOYOO Pro Micro 5V/16MHz Module Board with 2 Row pin Header Replace wit Pro Mini for Arduino

Spice up your DIY keyboard builds with this little microcontroller, which works with the TMK and QMK firmware. It's got 18 pins for you to work with.,